Note: We recommend that installation is undertaken by a competent plumber or heating engineer. When mounting, do make sure that the surface onto which the radiator is fixed will provide a secure location for fixings.
Iguana Arco Installation Guide
Iguana Arco Venting instructions
The instructions below are to be read in conjunction with downloadable venting and installation instructions above.
Check that the fixings pack includes all of the items detailed on the mounting instructions. Please note that no valves are included.
On the chart
Take “L” the Length of the Arco then take “C” for the corresponding bracket hook centres, i.e. L51.9cm = C38.0cm bracket centres.
Fig 1a, 1b & 2
Mark out fixing positions, drill holes and mount the bracket hooks using the bolts supplied.
Fig 3 &4,
Mount the Arco by removing the packaging and lifting it high enough so that the back location slots will locate over the wall bracket and then slide down into place.
Carefully fit the threaded air vents on both sides.
Plumb Arco in as shown using PTFE tape if necessary (refer to valve installation instructions). The flow and return can be either side but ensure that the valves are correctly positioned.
Close the Return valve & open the Flow by 10%. Water should be allowed to flow in slowly to prevent the formation of airlocks. Vent from the air vent on the side opposite from the flow in. Once the radiator is filled with water close the air vent and open both valves fully.